6
Brake
The Hydraulic brake is the only brake of the Euro Scooter and has to
be checked each time before you use the scooter. The parking-brake is
operated by clamping the brake lever in the disengaged position. The
parking brake can be loosen by pulling the brake lever and lifting the
clamp.
Handlebar basket
The Euro Scooter is equipped with a handlebar basket.
Hang the basket on the front part of the handlebar.
The basket has a maximum load capacity of 10kg / 22lb which should not be
exceeded. Note that a filled basket with significantly influence the driving behavior.
Electronic
The battery status display shows the charge status. If the display is in the green
range, the battery is sufficiently charged. If the display is in the red range, the
scooter can only be used for a short distance and the battery should be charged as
soon as possible. If you do not use the scooter for longer timer the battery should be recharged. If you do not use the scooter turn of the
electronic. Protect the electronics and the battery against water and or Frost, otherwise this may result in malfunction of the scooter.
Charging the Battery
Attention!!:
Always connect the power adapter to your EuroScooter first BEFORE you plug it into the power outlet.
For an optimum state and capacity of the battery we recommend charging the battery at room temperature.
To charge the battery:
1.
Turn off the scooter and remove key
2.
On the lower back side of the scooter, open the cover of the charging jack.
3.
Connect the battery charger to the scooter.
4.
Plug the main plug of the battery charger into the main socket (230 V).
5.
Charging time is about 4 to 5 hours.
6.
If is the charge indicator is green of the battery charger, the battery is fully charged.
7.
Once charging is complete, disconnect the mains plug and disconnect the
battery charger from the scooter.
8.
Close the cover of the charging jack.
Battery replacement
If the rechargeable battery is exhausted after several years, please contact your dealer or isel for an appropriate exchange. Battery
replacement must always be performed by a certified dealer or must be done by isel professionals.
After the battery is replaced, charging the battery is first required before use the scooter.
Charging process is finished.
At the start of the charging
process the charger indicate
the actual voltage.
The status LED's on the
charger lights alternating red
P-Pulse and green N-Pulse
