isel
-PSPCI V3 User Manual
3
3
.
.
5
5
.
.
2
2
.
.
3
3
Inputs
and
Outputs
Inputs and Outputs
Fixed predefined inputs and outputs can be configured in this frame. In each case one byte
will be addressed. Please enter the hexadecimal offset of the basis-address in the address-
field.
The mask allows the selection of the bits which should be used for input and if they should be
inverted (-) or not (+). Click on the space above the diode to change the bits.
The inputs will only be read if ">" is selected. Each change of the output state will be written
immediately to the corresponding address. The gained values can be re-imported through
appropriate outputs by selecting ">".
The LED shows the status of the bits read:
•
Deselected:
grey
•
Input bit "1":
red
•
Input bit "0":
blue
•
Non inverted bits ("+") are shown normally.
•
Inverted bits ("-") are shown in an inverted mode.
•
Deselected bits (" ") are shown with shadowed colours.
Inputs
The PCI card inputs are already
pre-adjusted. The inputs no. 1 –
8 serve the evaluation of the
hardware limit switches.
The classification of the
limit switches must not be
changed!
Seite - 15
