81
8. PERIODICAL INSPECTION TABLE
CHAPTER 5. INSPECTION AND MAINTENANCE OF MAJOR PARTS
Check points
Pre-
operation
Inspection and servicing
intervals (hours of operation)
Intervals after that
Judgement criteria
Ref.
page
50 100 150 200 250
Blade
○
Deformed, broken, worn,
and cracked ones should
be replaced.
Bevel gear case
oil
●
○
○
○
●
Replace after initial 50 h. and
then after every 200 h.
Maintain the specified
level.
Belt tension
○
Tension Spring length
5.12in. (130 mm)
Roller and gauge
wheels
○
They should turn
smoothly.
Belt cover inside
△
△
△
△
△
Clean after every 50 h.
There should be no grass
or dust accumulated.
Belt
○
○
○
○
○
Clean after every 50 h.
Criteria for replacement:
• Deep crack over half the
thickness of belt.
• Worn out side wall canvas
Greasing points
○
○
○
○
○
Grease up after every 50 h.
Bolts and nuts
○
There should be no loose ones.
Pins and clips
○
There should be no lost or
deformed ones.
○
:Inspection, replenishment, and adjustment
△
: Cleaning and washing
●
: Replacement
★
: Consult your dealer.
IMPORTANT:
• Above mentioned service intervals should be used as reference criteria. If working conditions are harder, earlier
service is recommended.
• When special technology and special tools are required, consult your dealers.
