iseg GPS 300W, Technical Documentation Manual

Page: 33 / 40

3 Remote control via interface
3.1 Description of the AIO interface
WARNING!
WARNING!
Before connecting or disconnecting the interface cable, the device must be switched off or disconnected from
the mains.
All analog and digital inputs and outputs are located on the D-SUB 9 connector. This connector has the following pin assignment:
AIO, D Sub 9 Connector
Pin 1 GND Return of pins 2-9
Pin 2 I
mon
(0 .. 5 V) (1 Monitor output current
Pin 3 INHIBIT Digital input signal
Pin 4 I
set
(0 .. 5 V) (1 Nominal value Output current
Pin 5 ON Digital input signal
Pin 6 Standard version GND Return of pins 2-9
Option ARC ARC Digital output signal
Pin 7 V
mon
(0 .. 5 V) (1 monitor output voltage
Pin 8 V
set
(0 .. 5 V) (1 Nominal value Output voltage
Pin 9 V
ref
5,1 V (1 Reference
Notes:
1)
optional AIO with V
set/mon
and I
set/mon
= 0 to 10V and V
ref
= 10,2V
Table 13: AIO
GPS High Voltage Power Supply Series | Last change: 10.01.2020 |
www.iseg-hv.com
33/40