ise smart connect KNX Hue
Installation, electrical connection and operation
Order No. 1-0002-003
Product Manual Page 17 (60)
Mounting/removing a cover cap
A cover cap can be mounted for protection of the KNX bus and power supply connections from dan-
gerous voltage, particularly in the connection area.
The cap is mounted with an attached bus and power supply terminal and a connected bus and power
supply line to the rear.
Mounting the cover cap: The cover cap is pushed over the bus terminal until you hear and feel it
lock into position (comp. Figure 2A).
Removing the cover cap: The cover cap is removed by pressing it slightly on both sides and
pulling it off towards the front (comp Figure 2B).
A
B
Figure 2: Mounting/removing a cover cap.
