12
You need a hex wrench to remove the screws on the rocker.
• When the disc brake is too sensitive, rotate the disc brake rocker down a bit. Then, reinstall the
screws back to the brake cable core to tighten.
• When the disc brake cannot stop, rotate the disc brake rocker up a bit. Then, reinstall the screw
back to the brake cable core to tighten.
Notice: The disc brake may squeak when in use until it is broken in. This is normal and does not
affect the brake's function or performance.
• Loosen two screws on the pump (not the screw on the rocker).
• Adjust the position of the disc brake pump to ensure that the brake disc is in the middle of the
two brake pads.
• Keep the brake disc and brake pad not touching each other.
• Hold the disk brake pump in the desired position, then re-tighten the screws to the pump.
First make sure the scooter is turned off. For easier operating, we suggest you put the scooter on
the desk.
To remove the disc brake noise:
To adjust the disc brake sensitivity:
Disc Brake Adjustment
