Unpack & Inspect
1
You should have:
• 1 Radiator
• 4 Wall bracket sleeves & 4 grub screws (attached to radiator)
• 1 Airvent with Chrome Cap (pre-installed)
• 1 Blanking Plug with Chrome Cap (pre-installed)
• Wall fixings; these are not suitable for wall types.
Please use suitable fixings for your wall type.
You will need:
• Tape measure
• Electric drill and bits
• Spirit level
• Crosshead screwdriver
Contents
2
Hang Radiator
3
Diagrams of Lynx
The Radiator Company prides itself on selecting products from
manufacturers who exercise tight quality control measures.
We only select models with excellent standards of welding and
brazing, as well as high quality finishes.
All of our products are well packaged and should reach you in
perfect condition. Just in case however, we offer a 10-year no
quibble guarantee on this product.
The Radiator Company must be notified of any shortages or
damage within 28 days of delivery.
PLEASE NOTE :
It is essential that all brackets are level to ensure a
vertical alignment for connecting the pipework.
Pipe Centres
Pipe centres left to right
Pipe centres from wall
Depth from wall
Commission
4
Please Note:
In accordance with Part L1 2006 of the Building Regulations and
BS7593:1992 code of practice for the treatment of hot water
and central heating systems, we strongly recommend flushing
the heating system post installation of new radiators and then
adding the correct quantity and type of inhibitor for use with
your radiator and system to prevent corrosion. Damage caused to
systems not protected by a suitable inhibitor will not be covered by
manufacturer’s guarantee.
430mm / width minus 70mm
55mm to 80mm
95mm to 120mm
For further information please see
terms and conditions on back page.
430
95 to 120
55 to 80
500
430
min. 110
Slide on the bracket sleeves over the
top two bracket studs on the back of
the radiator.
Lift the radiator in its final desired place
and mark the position of the bracket.
Carefully set the radiator aside and
hold the top two bracket sleeves to the
wall on the markings, and mark through
the centre of the bracket for drilling.
Use a spirit level to check the markings
are horizontally aligned.
Using suitable drill bits, plugs and
screws, loosely fix the top two brackets
to the markings. Check the position
by placing the radiator in position. If
correct, securely tighten the bracket
sleeves to the wall.
With the top two brackets fixed, lift
the radiator into position on the top
two brackets (please ensure sufficient
support is given to the radiator at all
times)
Mark the position for the bottom two
brackets then repeat steps 1 to 3.
With all 4 bracket sleeves securely
attached to the wall, hang the radiator
and secure with the provided grub
screws into the side of the bracket
sleeves.
1.
2.
3.
5.
1.
2.
3.
4.
5.
