You should have:
1 Radiator
4 Brackets (consisting of two parts and a screw)
1 Fixed Diverter -
the diverter for the Kura is fixed and cannot be
moved, it is positioned between the 1st and 2nd element from the left
(please see diagram opposite)
You will need:
Suitable drill bits, plugs and screws for your wall type
3mm Allen Key
Crosshead Screwdriver
Spirit Level
Drill
Contents
2
Diagrams of Kura
PLEASE NOTE :
It is essential that all brackets are level to ensure a vertical alignment for
connecting the pipe work.
4
Commission
5
Unpack & Inspect
1
The Radiator Company prides itself on selecting products from
manufacturers who exercise tight quality control measures. We
only select models with excellent standards of welding and
brazing, as well as high quality finishes. All of our products are well
packaged and should reach you in perfect condition. Just in case
however, we offer a minimum 5-year no quibble guarantee for all
radiators and towel rails.
Please carefully unpack and inspect this
radiator and all fittings.
The Radiator Company must be notified of
any shortages or damage within 28 days of
delivery. For further information please see
terms and conditions on back page.
In accordance with Part L1 2006 of the Building Regulations and
BS7593:1992 code of practice for the treatment of hot water and
central heating systems, we strongly recommend flushing the heating
system post installation of new radiators and then adding the correct
quantity and type of inhibitor for use with your radiator and system
to prevent corrosion. Damage caused to systems not protected by a
suitable inhibitor will not be covered by manufacturer’s guarantee.
Fix Brackets and Hang Radiator
Pipe Centres
Pipe centres left to right
Pipe centres from wall
Depth from wall
width - 15mm + Valves
30mm - 75mm
90mm - 135mm
Mark Bracket Positions
3
Same dimensions for all horizontal and vertical models:
85
85
65
65
width - 15mm + valves
(pipe centres)
Minimum
depth from wall & pipe centres from wall
90
30
135
75
Maximum
depth from wall & pipe centres from wall
1.
Brackets are supplied fixed to
the radiator. Loosen the L-Shape
bracket withan Allen Key, tilt
up (to the position shown) and
tighten.
2.
Stickers are available to use on the L shape brackets to mark out the
bracket positions on the wall; the top layer needs to be peeled off, and
you can then lift your radiator and press against the wall, and the stickers
will stick to the wall in the bracket positions. If you prefer you can use the
dimensions in the diagrams opposite to mark out the bracket positions.
3.
Remove the L-Shape bracket from the radiator
and fix to the wall in the positions shown, using
a suitable drill bit, plugs and screws. Use a spirit
level to ensure the brackets are vertically and
horizontally level.
4.
Lift up the radiator and place into position.
The top brackets will sit under the top collector
as support.
5.
Using an allen key re-attach the L-Shape
Brackets to the bracket body on the top two
brackets first, then the bottom.
6.
The Brackets can slide along the collector to
alter the position of the radiator.
Ensure the radiator is in its final position and
secure the brackets in place using a 3mm Allen
key on the grub screws on the bracket body.
60
60
(recommended)
(recommended)
x
x =
fixed diverter position
