![IROX PE-DRO Operating Instructions Manual Download Page 7](http://html1.mh-extra.com/html/irox/pe-dro/pe-dro_operating-instructions-manual_2091751007.webp)
4.4
The function
KM
Distance covered
In this function, the number of steps and the step length you have defined are used to calculate the distance
covered.
This function is reset together with the daily step counter (
STEP
).
4.5
The function
KCAL
Kcal burned
The calories burned during the actual measurement.
Please note: 100g of chocolate are the equivalent of approx. 500 kcal!
This function is reset together with the daily step counter (
STEP
).
4.6
The function
ACTIVITY TIMER (MIN)
Movement timer – measurement of time in minutes when walking
This timer shows for how long you have been active, i.e. the timer starts as soon as the step counter
displays a movement. This means you see at a glance how long it has taken you to take a certain number of
steps. The time is reset together with the daily step counter.
4.7
The function
STEP TOTAL
Totalizer for all measurements (STEP TOTAL)
The measurement data added since the last complete RESET are collected here.
Select the measurement data: with the SET key
Complete reset (RESET) of the measurement data
Press and hold the
RESET
key for at least 4 seconds. All measurement data, apart from the data in
ODOSTEP, are then deleted!
5.
Change / activation of batteries
- The cover of the battery compartment is located on the reverse of the device. You can use a small cross-
head screwdriver to open the battery compartment.
- With a new device, open the battery compartment and remove the insulating strip.
When using a device with a discharged battery, replace the old battery with a new one, type CR2032 (3V).
Please ensure correct polarity (the positive pole upwards, i.e. visible for you when you insert the battery)!
- Close the battery compartment and tighten the screw again.
6.
Pedometer care
- Do not expose the device to extreme temperatures or direct sunlight over longer periods.
- Avoid blows and shocks of any kind to the device.
- For cleaning use a dry soft cloth that you have moistened with water and a mild cleaning agent. Never use
volatile substances such as benzene, thinner, cleansing agents in spray cans etc..
- When your pedometer is not being used store it in a dry area and out of the reach of small children.
- If the device is activated under extreme coldness it may occur that the display becomes illegible. As soon
as the pedometer is returned to a warm environment the device will function normally.