20
The timers can not be active together at the same time.
Some special functions can be carried out with the two timers:
INT.LEAVE
(Interleave):
After the countdown of timer 1, timer 2 starts
automatically.
REPEAT
(Repeat):
As soon as the active timer has counted down
(in Interleave after the countdown of timer 2),
the counter begins again with the countdown.
CT BEEP
(Countdown tone):
During the countdown, at certain times,
acoustic signals will sound: A 1 second beep for
each of the last 5, 4, 3,2 and 1 minutes
A 1 second beep for each of the last 50, 40, 30,
20 and 10. During the last 5 seconds a fast
beep-beep will sound. This function can be
used as a Regatta Timer, for example.
At the end of the countdown, when the timer reaches 0:00:00, there will be a signal
(length: 20 seconds)
Time setting of the timer: from 0:01 to 9:59 hours in minute steps.
The commands for setting the time of the timer are as follows:
With these buttons you change the setting value
Skip to the next setting value (until you leave the set mode)
Functions and operation •
