Page 8 of 14
2. Pull the handle back until it is fully extended. Lock it into place with the locking plate.
3. Remove the cap and/or lid from both ends of the cartridge (not included). Insert the cartridge into
the tube container in the direction indicated on the cartridge. Make sure that the cartridge is as far
in as possible.
4. Reconnect the tube container to the main head. Press the locking plate to release the T-handle.
Press the handle in as far as it will go.
5. Make sure the end of the grease cartridge that is inserted into the tube container is not damaged
or squeezed. It should still be round. If it is damaged, the plunger will be prevented from entering
the grease cartridge. This will prevent the grease from leaving the tube.
Note: Do not re-use empty grease cartridges.
Suction Filling
1. Remove the tube container from the main head.
2. Submerge the open end of the tube container approximately 2 inches into the grease container
