Page 13 of 24
Do not point the hammer at anyone in the area when operating. The bit could fly out and seriously
injure someone.
Burn hazard. Do not touch the bit or parts close to the bit immediately after operation; they will be
extremely hot.
Use only well-sharpened bits that are in good condition and appropriate to task.
To prevent the bit from jamming, keep the motor running when pulling the bit out of a completed
hole.
Switch Operation
To turn the switch ON, press the 1 button.
To turn the switch OFF, release the 2 button.
Note:
Sometimes the demolition hammer does not begin striking even when the motor is running
because the oil inside has becomes too thick. If the demolition hammer is used at a low temperature,
or it is used after a long idle time, it needs to run for a little over 5 minutes to warm up.
Grease and Oil Filling
1. Using a 12mm Hex head wrench (NOT included), loosen the 4 screws between the aluminum
head and the gear box.
