Page 11 of 27
Slide Lock Knob
When tightened, the slide lock knob (FIGURE 3) prevents the saw head from sliding along the slide
bar. Tighten the slide lock knob during transportation to prevent accidents.
Miter Table Lock
The miter table lock is used to lock the table at the desired miter angle (FIGURE 4). The miter saw
cuts from 0° to 45° both left and right. To adjust the angle, loosen the miter table lock, hold the miter
release handle, and rotate to the desired miter angle. Relock the table in place by tightening the miter
table lock.
The miter table features positive click stops at 0°, 15°, 22.5°, 31.6°, and 45° in both directions for
quick setting of common miter angles.
Bevel Lock
The bevel lock is used to set the blade at the desired bevel angle (FIGURE 5). The miter saw bevels
from 0° to 45° left only. Hold the operating handle and loosen the bevel lock to set the bevel angle.
Tighten the bevel lock.