Ironton 61482, Owner'S Manual

Page: 9 / 17

Page 9 of 17
Lubricating the Metal Shear
1. Make sure that the power switch is in the OFF position and plug in the metal shear.
2. Turn on the metal shear and run for one minute.
3. Turn off the metal shear and unplug from the outlet.
4. Place 3-4 drops of light machine oil in the oil port.
5. Turn the metal shear on its side and place 1-2 drops of light machine oil above the upper blade.
Note : Make a few practice cuts on scrap material before cutting your workpiece.
Operating Instructions
⚠
WARNING

Do not use to cut sheet metal that is thicker than 14 gauge.

To reduce the risk of injury, always wear eye protection.

Hold power tool by insulated gripping surfaces, when performing an operation where the cutting
accessory may contact hidden wiring or its own cord.

Never leave the tool unattended when it is plugged into an electrical outlet.

Never lay the tool down until the motor has come to a complete stop.

The edge of sheet metal is very sharp. Always wear protective gloves when handling sheet metal.

DO NOT touch, change, or adjust the angle grinder until it is cool. Blades heat up dramatically
while in use and can burn you.

Do not use with the trigger locked on.