Page 8 of 14
6. Tighten the chuck using the provided multi-wrench.
7. Screw on
the chainsaw’s sharpening guide and adjust:
8. The sharpening guide must be adjusted up or down on the mounting plate so the correct amount of
the
stone’s diameter will be exposed.
9. To adjust the stone to the correct depth, loosen the screws on the mounting plate of the sharpening
guide.
10. Place the multi-wrench on its side with the four round notches down upon the face of the
sharpening guide. The four notches correspond
to the different stone sizes (5/32”, 3/16”, 7/32”, and
4.5mm).
11. Position the correct size notch over the stone seated in the aperture of the chain guide. Adjust as
described previously and
you’re now ready to sharpen.
