Ironton 54127, Owner'S Manual

Page: 6 / 18

Page 6 of 18

Use only accessories that are recommended by the manufacturer for use with your electric winch.
Accessories that may be suitable for one product may create a risk of injury when used with
another tool. Never use an accessory that has a lower operating speed or operating pressure than
the tool itself.
Specific Operation Warnings
⚠
WARNING
GENERAL SAFETY

To prevent injury or property damage, read and understand all instructions before operating
winch.

Wear ANSI Z87.1 compliant safety goggles and heavy duty leather work gloves during
operation.

Do not exceed the rated load capacity. Be aware of dynamic loading! Sudden load movement
may briefly create excess load causing product failure.
INSTALLATION SAFETY

Choose a mounting location that can support the winch and rated load capacity.

Do not weld mounting bolts

Use supplied power cords and wire rope listed in manual only. Do not use thinner/longer cables
or link multiple cables together.

Keep hands clear of winch rope, hook loop, hook and fairlead opening during installation,
operation, and when spooling in or out.

Wrap the wire rope under 500 lb. of tension before use. Otherwise, the wire rope may bind
during operation.

Do not route electrical cables near sharp edges or parts that will move or become hot.

Ventilate area well before and while working on battery. Explosive hydrogen gas can
accumulate and explode when ignited by a spark or open flame.

Only connect to a clean, corrosion free battery.

Remove all jewelry and metallic objects before working near battery.
WINCHING SAFETY

Inspect winch rope, hook, and slings before operating winch. Frayed, kinked, or damaged winch
rope must be replaced immediately. Damaged components must be replaced before operation.

Do not maintain power to the winch if the motor stalls. Verify the load is within the rated capacity
for the wire rope layer. Make sure the battery is fully charged. Use double line rigging whenever
possible.

Do not engage or disengage clutch while under load.

Always ensure hook latch is closed and not supporting load.

Never apply load to hook tip or latch. Apply load only to the center of hook.

Never use a hook whose throat opening has increased, or whose top is bent or twisted.

Keep clear of fairlead when operating. Do not try to guide wire rope.

Do not place any fingers through the hook. Fingers may be caught and get pulled into the
fairlead or drum. Use the included strap to hold the hook instead.