Page of 13
9
Reversing the Rotational Direction
The rotational direction switch (7) is used to reverse the rotational direction of the machine.
However,
this is not possible with the On/Off switch (9) actuated.
Right rotation:
Turn the selector switch for drilling/hammer drilling (7) on both sides to the stop in
the position
.
Left rotation:
Turn the selector switch for drilling/hammer drilling (7) on both sides to the stop in the
position
Set the direction of rotation for hammer drilling, Drilling and chiseling always to right rotation.
Switching On and Off
To start the machine, press the On/Off switch (9).
To lock the On/Off switch, keep it pressed and additionally push the lock-on button (8).
To switch off the machine, release the On/Off switch (9). When the On/Off switch (9) is locked,
press it first and then release it.
Setting the Speed/Impact Rate
The speed/impact rate of the switched on power tool can be variably adjusted, depending on ho far
the On/Off switch (9) is pressed.
Rotary speed control knob (6), from A to F and faster. Light pressure on the On/Off switch (9)
results in low speed/impact rate. Further pressure on the switch increases the speed/impact rate.
Overload Clutch
If the tool insert becomes caught or jammed, the drive to the drill spindle is interrupted.
Because of the forces that occur, always hold the power tool firmly with both hands and provide for
a secure stance.
If the power tool jams, switch the machine off and loosen the tool insert. When switching the power
tool on with the drilling tool jammed, high reaction torques can occur.
Summary of Contents for 32185
Page 5: ...Page of 13 5...
