13
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
(For ash drawer pedestal see instructions included with pedestal)
Residential and Mobile Homes
(Bolting down and grounding are required only in mobile homes)
CAUTION
:
Wear gloves during installation in case of sharp
edges on the stove.
1. Remove the heater from the carton, if packaged, upon receipt and
check for any damaged or missing parts.
2. Carefully put the stove on pedestal with the open end of the pedes-
tal facing the rear.
DO NOT LEAVE THE STOVE UNATTENDED
UNTIL IT IS BOLTED SECURELY TO THE PEDESTAL
.
3. Line up the holes in the brackets on the pedestal with the threaded
holes in the bottom of the stove. Use the two 1/2” long bolts and
3/8” standard washers to bolt the stove to the pedestal. Be sure
to see that the stove is mounted squarely on the pedestal before
tightening the two bolts securely.
4. When installing a pedestal on this stove you MUST plug the four
leg mounting bolt holes, on the bottom of the stove in the four front
corners, with the bolts that were used to mount the shipping legs.
The two rear bolts should not be installed more the two full rotations
to prevent lifting the bricks off the bottom of the stove.
FAILURE
TO INSTALL THESE FOUR BOLTS PROPERLY WILL RESULT
IN REDUCED CONTROL OF THE STOVE’S COMBUSTION
SYSTEM!
5. If required, install the Outside Air Kit (cat. no. 71112) as per the
following instructions. To locate the hole in the hearth for outside
air mark and cut a 4” (102 mm) hole in the hearth. The hole’s center
should be 3” (76 mm) directly forward from the center of the flue
outlet or locate as per the instructions below.
6. Position the stove on your floor protection in the exact location
where it is to be located, making sure all minimum clearances are
met. Mark the floor protection where the pedestal will be located,
then remove the stove.
7. Make four 1-1/2” (38 mm) cuts in one end of the corrugated tube
and fold the flaps back. Cut a 4” (102 mm) hole through the floor
protection and the floor and insert the corrugated tube into the hole.
Cover it with the supplied screen and fasten it to the floor protec-
tor.
8. Locate the 11-1/2” x 14” (292 mm x 356 mm) metal plate and paint
to match the stove if necessary. Position this piece so that the 14”
(356 mm) dimension evenly overlaps the lips on the back of the
pedestal (see drawing below). Attach this plate to the back of the
pedestal with the self-tapping screws supplied.
9. If the stove is to be fastened to the floor, attach the stove with the
supplied lag bolts, through the pedestal base on opposite sides,
attaching them into the floor beneath the floor protection. Seal any
irregularities with silicone sealer.
10. If installed in a mobile home, the heater shall be grounded to the
chassis with a #8 AGW copper wire or equivalent.
11. Install bricks as per instructions on
Pages 14 and 15
. It is highly
recommended that the baffle be assembled before the chimney is
installed so that the baffle blankets can be adjusted into place from
the flue outlet.
12. Install chimney as per manufacturer’s instructions.
Figure 13
PEDESTAL INSTALLATION
Block Off Plate is
Required When
Installing Outside
Air Into Unit (Plate
is Included With
Kit # 71112)
Summary of Contents for Canyon ST310
Page 30: ...30 NOTES...
