Page 11 of 16
BB067
Installation Guide
©Copyright 2022 Ironman 4x4 Pty Ltd. No part of this publication may be reproduced or replicated without the prior written consent of Ironman 4x4 Pty Ltd
3.
Fit sensor with factory silicone
sleeve to the sensor holder and
secure using clamping plate and
screws provided. Do not over
tighten. Clamping plate has a flat
side for thicker sensors and a
raised section on the other side for
thinner sensors. It is important that
clamping plate is the correct way
around as sensor will false alarm
if excess pressure is applied to the
sensor body.
4.
Clean inside of bullbar around
sensor holes and mounting surface
of sensor holders using wax and
grease remover.
