300w Easy Setup Feature
The steps you should follow are summarized below:
1)
Pull the stereo jack from the plug in the back of the
300w
2)
Remove the battery cover from the back of the unit by gently pressing down the tab and
pulling out.
3)
Install 2 “AAA” batteries with the positive end facing down and replace battery cover
4)
Plug the 3.5mm stereo cable into the audio out connector or the headphone jack of the
audio source you wish to transmit.*
5)
Select the frequency that you wish to transmit to with the selector on the side of the
300w
(88.1, 88.3, 88.5 or 88.7 MHz)
6)
Press the POWER button on the front of the unit (LED will be lit up when powered
properly)
7)
Tune your FM stereo to the corresponding FM frequency as selected in step #5.
8)
Adjust the volume on your audio player and stereo for maximum enjoyment.
*Some audio sources output level is either too high or to low at the line-out jack. If it is too high, the sound might be distorted. If it is too low,
the sound might be too noisy. If this happens, connect the transmitter’s plug to the headphone jack and adjust the volume level on your audio
device.
Frequently Asked Questions about the irock!
300w
Q: What is the
300w?
A: The irock!
300w
is the newest product offering from First International Digital
.
The
300w is
a
portable audio transmitter that connects to any audio source and broadcasts that audio to any radio or
stereo within 10-30 feet.
Q: How can I achieve maximum performance and sound quality from my
300w?
A: 1) Maintain fresh batteries.
2) Turn the
300w
off when not in use.
3) Keep the
300w
within 10 feet of the radio that it is transmitting to.
4) Keep the cord that connects the
300w
to the audio player straight/taut, positioning the player as far
from the
300w
as possible.
5) Before using the
300w
listen to 88.1, 88.3, 88.5, and 88.7 FM on your radio and use the frequency
with the weakest radio station.
Q: Should I connect my
300w
to the Audio Output or Headphone Output of my player?
A: It depends on the output level of your source’s Audio Output. If you are getting a distorted or noisy
sound when connected to the Audio Output try connecting the
300w
to the Headphone Output and adjust
the volume levels on your source and stereo for maximum enjoyment.
Q: When I press the power button the LED blinks on, then off, yet nothing works, how do I fix
this?
A: The flickering on and off of the LED is a low battery indication. Replace both “AAA” batteries
and continue normal use.
Limited Warranty Information
First International Digital (FID) warrants that the product enclosed herein to be free of defects for a
period Ninety (90) Days from the date of purchase. In the event of a defect in material or workmanship
during the warranty period, FID, at its discretion, will repair or replace the defective product when the
owner returns the defective product to FID. The remedy for this breach of warranty is limited to servicing
or replacement only and shall not cover any other damages and shall not cover any other damages,
including but not limited to the loss of profit, special incidental, consequential, and other similar claims.
In no event will FID be liable for any amount greater than the currently suggested retail price.
.