www.irobot.com
3
Troubleshooting
Problem
likely Cause
what to Do
Verro moves
slowly or
has stopped
moving
The filter bag needs to
be cleaned
Flaps in the vacuum
intakes at bottom of
robot are blocked
Wheels or axles are
not turning freely
The pump propeller is
fouled by dirt or debris
Clean the filter bag. (p. 15)
Check the flaps in the vacuum intakes. (p. 22)
Check wheels and axles for dirt and debris.
Clean the pump propeller. (p. 20)
Verro does
not cover
entire pool
The filter bag needs to
be cleaned
Floating power cord is
not positioned to allow
Verro to reach all of pool
Flaps in the vacuum
intakes at bottom of
robot are blocked
Wheels or axles are
not turning freely
The pump propeller is
fouled by dirt and debris
Clean the filter bag. (p. 15)
Move Power Supply so that it is near the middle
of a long side of the pool, while maintaining a
minimum of 12ft away from pool.
Check the flaps in the vacuum intakes. (p. 22)
Check wheels and axles for dirt
and debris.
Clean the pump propeller. (p. 20)
Most problems with Verro are caused by a dirty or clogged filter bag. Verro
depends on water flowing freely through the filter bag to operate at peak
efficiency. If the filter bag gets clogged, Verro will not be able to clean as
effectively and may not move as well. See “Cleaning the Filter Bag” for bag
cleaning instruction.
If you find the fine filter bag gets clogged too quickly (e.g. you have significant
amounts of larger debris), consider a mesh bag instead.
Always turn off Verro’s Power Supply and unplug it before troubleshooting
any problem.
Summary of Contents for Verro 100
Page 1: ...iRobot Verro Owner s Manual Model 100 1 877 855 8593...
Page 27: ......
