ircon Modline 5, Operating Instructions Manual

Page: 52 / 156

Sensor Installation
50
Rev. L6 Feb 2017
Modline 5
Dimensions are in inches and (millimeters). Do not scale.
3.10 Accessory Combinations with Break-out Drawings
3.10.1 Recommended Accessory Groupings
The table below lists the eighteen recommended accessory groupings. Exploded views of the groups
are shown on the following two pages.
The recommended groupings for Sensors with the Dirty Window Detector are identified in the DWD
column. See Section 3.8
DWD Installation Requirements , for more information. Groups are illustrated
with dimensions in Section 3.11 Installation Drawings and Illustrations .
Group Mounting Option Required Accessories
DWD
See Notes
1 ¼-20 Bolt Pattern Mount UAA N. R. (1)
2 Large Flange Interface Mount UAA MFL Add ESA (3)
3 Air Purge with ¼-20 Bolt Pattern Mount UAA APA Add ESA (2)
4 Air Purge with Small Flange Mount UAA APA MFS Add ESA (2)
5 Air Purge with Large Flange Mount UAA APA MFL Add ESA (2)
6 Right Angle Base Mount UAA RAM N. R. (1)
7 Right Angle Mount with Air Purge UAA RAM APA Add ESA (2)
8
Right Angle Mount with Large Flange.
This group requires an ESA for clearing the
RAM
UAA RAM
MFL &
ESA ESA Included
Note 3
9 Right Angle Mount with Air Purge UAA RAM APA MFS Add ESA (2)
10 Right Angle Mount with Air Purge UAA RAM APA MFL Add ESA (2)
11 Water Jacket, Air Purge and Small Flange APA WJA MFS Add ESA (2)
12 Water Jacket with Large Flange Mount WJA MFL
Add ESA
(3 and 5)
13 Water Jacket, Air Purge and Large Flange APA WJA MFL Add ESA (2)
14 Water Jacket, Base Mount WJA BMA N. R. (1)
15 Water Jacket, Base Mount, Air Purge APA WJA BMA Add ESA (2)
16 Water Jacket, Base Mount and Large Flange WJA BMA MFL
Add ESA
(3 and 5)
17
Water Jacket, Base Mount, Air Purge
and Small Flange
APA WJA BMA MFS Add ESA (2)
18
Water Jacket, Base Mount, Air Purge
and Large Flange
APA WJA BMA MFL Add ESA (2)
DWD is Dirty Window Detector Option. See ESA on previous page for more information. Also see Sections 3.8 DWD Installation
Requirements and 3.9.6 WJA – Water Jacket Accessory Description and Dimensions .
Notes:
1. N. R. = Group Not Recommended for Sensors with DWD.
2. USE the ESA and APA air purge with clean air for air purging and stray radiation shielding. Use APA without air to
create a dead air space zone and shielding. The use of an APA is required for large targets over 1000

C.
3. The ESA with MFL provides dead air space and stray radiation shielding. Add an AA-3 air purge accessory for air
purging. See Section 3.12 Other Accessories (Sight Tube, Window, WJ-5 Water Cooling) , page 60 for AA-3
information. These combinations not recommended for large targets over 1000

C.