iRay Technology InfiRay Jerry-F, User Manual

Page: 17 / 19

Jerry-F can be connected to a Tyke series
thermal scope via Wi-Fi to provide video
functions. Before connection, you need to
match Tyke thermal scope with Jerry-F.
The matching method is as follows:
1. Loosen the four screws on the battery
holder of Jerry-F, and you can see the
matching button for image transmission
near the aviation connector in the
underlying PCB. Turn on the power of
battery holder, then turn on the image
transmission power, and the indicator on
the image transmission plate is on. The
indicator is solid for 8 s and then goes off if
there is no image access.
2. Operate the thermal scope. Enter the
menu of the thermal scope. Choose “Image
Transfer > AV > On”; choose “Wi-Fi > On”;
choose “RTA > On”. Then you can see the
“Connecting” countdown.
3. Press the connecting button (Jerry-F
matching button for image transmission)
for 5 s until the indicator blinks. Image
transmission and the thermal scope start
connecting.
4. When the image transmission indicator
turns to be fast blinking or off, the match
succeeds. Restore the power of battery
holder. The indicator is solid and then
changes to fast blinking, indicating matching
success. Install the cover of the battery
holder and tighten the four screws.
Caution: Jerry-F can only match one
thermal scope at one time.
Caution: To reduce power consumption,
AV and Wireless image transmission are
disabled by default upon startup. After
matching success, enable AV and Wireless
image transmission, rather than
Head-mounted Transmission.
Note: Jerry-F and the thermal scope are
one-to-one. You only need to enable
Head-mounted Transmission once and
shall re-match only if a change is made to
the thermal scope or Jerry-F.
After the battery holder of Jerry-F matches
the Tyke series thermal scope, you can
transmit videos and instructions via Wi-Fi.
To observe the videos of the thermal scope
from the main body of the goggle, connect
the main body of the goggle with the
battery holder by an aviation cable as
follows:
1. Take out the aviation cable from the
package;
2. Open the waterproof cap of the aviation
socket on the battery holder and the main
body of the goggle;
3. Insert the aviation cable to the aviation
socket by aligning the end of the cable with
a white dot with the white dot on the socket
on the goggle;
4. Turn on the main power of the battery
holder and then turn on the image
transmission power.
5. On the Tyke series thermal scope, enable
AV and Wireless image transmission. At this
time, if you press the I
2
knob, PIP and full
screen for thermal scope video will be
available when you switch the display
mode.
3.7 Wi-Fi and Video Access
12
Jerry-F User Manual V1.3
Mainpower of battery
holder
Image transmission power
Image transmission
indicator
Matching button for
image transmission
Aviation socket for
image transmission