Iradion Infinity 1625, Operator'S Manual

Page: 33 / 34

30
The outer dust filter is removed by rotating it slightly counter clockwise and pulling up.
This outer filter uses a bayonet type engagement.
The dryer filter is removed by unscrewing it from the plastic base. These filters come
with a red plug in each end. The plugs must be removed before installation. In
addition, the dryer filter installed in the power supply unit is shipped with these plugs in
place.
The laser will not operate until the dryer filter is unscrewed from the filter
housing and the plugs removed! The laser is shipped with two spare DFD-10 dryers.
Serviceable Parts
Part Name Manufacturer Part # Service Period Method
Primary
Filter Arm & Hammer 62642D As required
indicated by dust
accumulation. Wash with
detergent and
warm water. Dry
thoroughly.
Secondary
Filter Arm & Hammer 62630G As required
indicated by dust
accumulation. Wash with
detergent and
warm water. Dry
thoroughly.
Dryer Filter Arrow Pneumatics DSD-10 Local Environment
Dependent. 700 hr.
MAX Inspect filter
window for blue
every 300hr. If
not present,
replace filter
Air Ventilation
The Power Supply and Air Pump module contains two closed-housing power supplies
that are individually forced-air cooled. The Power Supply and Air Pump module requires
adequate air ventilation for cooling and accommodations must be considered when
mounting and/or integrating this module.