iquatics Bio Phos Reactor Quick Start Manual Download

Page: 1 / 2

Ensure that the pump inlet and impellor are regularly

cleaned and kept free from debris.
The Reactor itself can be emptied and the centre

pipe carefully lifted out, complete with the bottom

plate and nozzles.

There are two plastic screws underneath the bottom

plate, which when removed, will disassemble the

jets to allow for thorough cleaning. When reassem-

bling, the screws only need to be finger tight.

MAINTENANCE

All plastic parts should be cleaned with fresh water only.

Q. What If clogging occurs?

This can be down to lack of flow, please

adjust the pump until you get a satisfactory

flow. Check that sponges are not clogged.

Q. I’ve adjusted the pump but

things still don’t seem correct?

Be carefull not to add/use to much media,

the pump supplied is sufficently strong

enough to adequately run this reactor, if you

are finding it not powerful enough you have

probably added a little too much media.

COMPANY REG 06954492 | VAT REG 978518363

WWW.IQUATICS.CO.UK

WE HOPE YOU ENJOY YOUR NEW IQUATICS REACTOR

Bio Phos

Reactor

TROUBLE SHOOTING

Summary of Contents for Bio Phos Reactor

Page 1: ...should be cleaned with fresh water only Q What If clogging occurs A This can be down to lack of flow please adjust the pump until you get a satisfactory flow Check that sponges are not clogged Q I ve...

Page 2: ...fit in one position 3 Ensure bottom sponge is under the plastic plate and the small red seal is sitting above this 4 WARNING the pump needs to be submerged in the sump Step 6 At this point you can po...