BATTERY REMOVAL INSTRUCTIONS
(FOR DISPOSAL AND RECYCLING)
Batteries must not be removed by the consumer. At end of product life, only an
authorized recycler may safely remove batteries by following the steps below.
IQOS ILUMA PRIME™ Pocket Charger (Model C1502):
Step 1: The device should be fully discharged before disassembling it.
Step 2: Remove/peel off the rubber pad from the Pocket Charger Wrap Cover.
Step 3: Remove the 2 screws.
Step 4: Remove Wrap Cover by sliding and wiggling vertically slowly away from Metal
Housing, then remove the 2 screws of the frame.
Step 5: Detach all Flexible Printed Circuits and connector to remove the charger Printed
Circuit Board.
Step 6: Remove battery by tilting it up and dispose of according to local regulations.
IQOS ILUMA™ Pocket Charger (Model M0001):
Step 1: The device should be fully discharged before disassembling it.
Step 2: Remove Door Cover with fingers.
Step 3: Open door and unscrew bottom and top screw.
Step 4: Remove Charger Housing.
Step 5: Unscrew the electronic circuit board (1 screw only).
Step 6: Unplug battery connector on the circuit board. Do not cut battery wires.
Step 7: Remove battery by tilting it up and dispose of according to local regulations.
IQOS ILUMA™ and IQOS ILUMA PRIME™ Holder (Model C1402):
Step 1: The device should be fully discharged before disassembling it.
Step 2: Open the Ring.
Step 3: Open the retainer cap, slide out the assembly out from housing.
Step 4: De-solder the battery tab and lifted it up.
Step 5: Remove battery and dispose of according to local regulations.
Confirmation of Compliance
Hereby, Philip Morris Products S.A. declares that IQOS ILUMA™ and IQOS ILUMA PRIME™
are in compliance with the essential requirements and other relevant provisions
of Directive 2014/53/EU. The official Declaration of Conformity may be found at:
www.pmi.com/declarationofconformity
IQOS ILUMA™ and IQOS ILUMA PRIME™ operate within 2.402 – 2.480GHz frequency band
with a maximum RF output power below 10.0 dBm.
This device complies with the RF exposure limits and has been evaluated in compliance
with portable exposure condition according to the EN 62311:2008.
Designed and manufactured under the authority of Philip Morris Products S.A.,
Quai Jeanrenaud 3, 2000 Neuchâtel, Switzerland.
Hogarth Worldwide
CR13082_H201137_P410023
null
Philip Morris International
Global
140.00 x 80.00 mm
140.00 x 80.00 mm
23/08/2021 17:18
PCool Gray 11
Black
