Getting Started with Your IQAir
®
HealthPro
®
Series
Thank you for choosing IQAir for your air cleaning needs. These instructions will assist you in getting started with
your IQAir system in a matter of minutes. Simply follow the instructions below. To access some of the more advanced
features of your IQAir system, such as the timer, please refer to the user manual. We recommend that you familiarize
yourself with the safety instructions in the user manual before first use.
Your IQAir system is supplied with the following items:
• User manual
• Certificate of performance (individually numbered and hand-signed)
• Technical support and warranty registration card
• IQAir referral program card
• Power cord
• Remote control (incl. battery)
• Set of 4 casters
Setting Up Your IQAir System
1
A) Unpacking
To unpack your IQAir system, open the top of the box and remove the top foam piece. Lay the box on its side and
pull the air cleaner out by its top handle. Place the system in its upright position and remove all packaging materials.
To provide a “plug-and-play” experience, the system has shipped with all filters pre-installed. During shipping it is
possible that some dust from the carbon filter may have become loose. This can be cleaned with a damp cloth.
B) Installing the casters
Installing the casters is not necessary to operate the system; however, it may facilitate moving the air cleaner from
room to room. Please refer to the user manual for caster fitting and removing instructions.
C) Choosing a suitable location
Your IQAir system should be placed in the room where air cleaning is needed. It should be located ideally one foot
(30 cm) away from the nearest vertical surface to allow for maximum air circulation.
D) Connecting to the power supply
Plug the connector-end of the power cord into the base of the system. Locate a suitable wall socket and connect
the power cord. Your IQAir system is now in standby mode, ready to be switched on.
Visit www.iqair.com/start for video instructions on how to set up your IQAir system.
A) Switching your IQAir system on and off
To switch the system on or off, simply press the POWER button, located on the far left of the control panel.
The system is intended to run continuously when users are present. Operating the system 24 hours per day
will not harm the system.
B) Regulating the fan speed
To select the desired fan speed, simply press the ARROW button on the control panel. When the top speed
has been reached, the display will start again at the lowest fan speed.
Using the Electronic Control Panel
2
(over)
