iQTS244
Operator’s Manual
888-274-7744
www.iqpowertools.com
En
gli
sh , E
N
Back and Side
Back
General
This section describes the machine
’
s safety equipment,
its purpose, and how checks and maintenance should be
carried out to ensure that it operates correctly.
WARNING!
NEVER USE A MACHINE THAT HAS
FAULTY SAFETY EQUIPMENT
BLADE GUARD
The blade guard is designed to prevent parts of
the blade or cutting fragments from being thrown
towards the user.
CHECKING THE BLADE GUARD
Check that the guard over the blade is not cracked or
damaged in any other way. Replace when damaged.
NEVER USE THE MACHINE
WITHOUT A GUARD NOR WITH A
DEFECTIVE GUARD. ALWAYS CHECK THAT THE GUARD IS
CORRECTLY FITTED BEFORE STARTING THE MACHINE.
IT IS NOT PERMITTED TO EXPOSE THE BLADE MORE THAN
180 DEGREES WITHOUT PROTECTION.
WARNING!
WARNING!
SHUT DOWN THE MACHINE AND
DISCONNECT THE POWER PLUG
BEFORE TRANSPORTING, MAINTAINING, AND CHANGING
THE BLADE.
DUST GUARD
The dust guard is designed to prevent dust being pulled
up from the backside of the blade. The dust guard should
be inspected periodically for damage. The dust guard
should move freely sliding up and over cutting material.
MACHINE’S SAFETY EQUIPMENT
SAW POWER SWITCH
The power switch
- / O
should be used to start and stop
the machine.
CHECKING THE SAW POWER SWITCH
The saw power switch starts the saw motor and
vacuum motor simultaneously.
To start the saw motor press the
POWER
switch
-
or
on symbol. To stop the saw motor press the
POWER
switch
O
or off symbol.
Defective switches should be replaced by an authorized
service workshop.
LASER SWITCH
This tile saw is equipped with a laser light guide for
lining up cuts.
To turn on the laser light guide press the
LASER
switch
-
or on symbol. To turn off the laser light guide press the
LASER
switch
O
or off symbol.
LOCKING KNOB, ROLLING TABLE
The locking knob is used to lock the rolling table in place
when in transit. Be sure to lock rolling table before
transit to avoid injury.
4.1
Blade Guard
Dust Guard
Blade Guard
Dust Guard
