iQPC912VSK
Operator’s Manual
888-274-7744
www.iqpowertools.com
- Now pull the starter handle and in doing so tension
the spring.
- Repeat the procedure once more, but this time with
four turns.
- Note that the starter handle is drawn to its correct
home position after tensioning the spring.
- Check that the spring is not drawn to its end position
by pulling out the starter line fully. Slow the starter
pulley with your thumb and check that you can turn
the pulley at least a further half turn.
TENSIONING THE RECOIL SPRING
Hook the starter cord in the notch in the pulley and turn
the starter pulley about 2 turns clockwise.
CHANGING A BROKEN RECOIL SPRING
- Undo the screw in the center of the pulley and remove
the pulley. Bear in mind that the return spring lies e
tensioned in the starter housing.
- Loosen the screws holding the spring cassette.
- Remove the recoil spring by turning the starter over
and loosen the hooks, with the help of a screwdriver.
The hooks hold the return spring assembly
on the starter.
- Lubricate the recoil spring with light oil. Fit the
pulley and tension the recoil spring.
RE-FITTING OR RE-INSTALLING THE STARTER
• To fit the starter, first pull out the starter cord and
place the starter in position against the crankcase.
Then slowly release the starter cord so that the pulley
engages with the pawls. Tighten the screws.
CHANGING A BROKEN RECOIL SPRING
- Undo the screw in the center of the pulley and
remove the pulley.
- Bear in mind that the return spring lies tensioned in
the starter housing.
- Loosen the screws holding the spring cassette.
- Remove the recoil spring by turning the starter over
and loosen the hooks, with the help of a screwdriver.
The hooks hold the return spring assembly on the
starter.
- Lubricate the recoil spring with light oil. Fit the pulley
and tension the recoil spring.
WARNING!
WARNING! WHEN THE RECOIL
SPRING IS WOUND UP IN THE
STARTER HOUSING IT IS UNDER TENSION AND CAN, IF
HANDLED CARELESSLY, POP OUT AND CAUSE PERSONAL
INJURY. ALWAYS BE CAREFUL WHEN CHANGING THE
RECOIL SPRING OR THE STARTER CORD. ALWAYS WEAR
PROTECTIVE GOGGLES.
MAINTENANCE & TROUBLE SHOOTING
Summary of Contents for iQPC912VSK
Page 2: ...M iQPC912VSK 0M 1218 ...
