DO NOT PRESS FOR LONGER THAN 2 SECONDS AS YOU MAY ERASE ALL EXISTING
CODES.
The light will turn ON, indicating the Lantern RX is in PROGRAM MODE and will remain ON up to
5 minutes. During this time, activate the Transmitter you are adding to send its code to the Lantern
Receiver and the light will go off. This code is stored in the Lantern Receiver along with existing
codes and the Lantern Receiver will now respond to the additional Transmitter.
Erasing All Codes.
Tx codes can be erased for reprogramming. To erase codes, while RX is powered, press and hold
the PROGRAM button for more than 5 seconds. The light will turn on, go out briefly then turn on
again. This will clear the Rx of all programmed codes and place it into the AUTO PROGRAMMING
Mode.
Note:- to prevent inadvertent programming by other transmitters, remove then gradually add
batteries or turn on power to the Tx you want coded to the Chime Rx during the AUTO
PROGRAMMING Mode.
SECTION FOUR
TECHNICAL SPECIFICATION
LANTERN RECEIVER
Power Supply
Maximum Switchable Load
Time On Adjustment
Dusk Timer Adjustment
Dimmer
Transmission Range
230/240 V AC ~ 50Hz
75W Max BC GLS or 23W Compact Fluorescent Lamp
(CFL)
1, 3, 5, 12 minutes (3, 5, 12 minutes for CFL)
2, 4, 8, hours and Dusk to Dawn.
Fixed at 30% of full power(
(NO DIM function if using a CFL)
Up to 60m (varies with surrounding structures)
If you experience problems refer to Troubleshooting Guide.
If problems still exist, do not immediately return the unit to store.
Telephone the IQ Customer Helpline
0871 7171100 Weekdays 9.00am - 5.00pm
[email protected] www.iq-europe.co.uk
Qualified Customer Support Co-ordinators will be on-line to assist in resolving your query.
SF-LA-BC-RX-W.qxd 13/04/2005 13:36 Page 6