Tune selection using PIR Transmitter:-
1. To place the Chime RX into Program Mode, press the “Prog” button for approx 1 second until a
single “beep” is heard. The LED will flash on and off indicating the Rx is in Program Mode
.
2. Activate PIR TX by walking into the detection area.
3. Scroll to tune required by pressing Tone/Volume selection button, until desired tone is reached.
4. Press “Prog” button for 1-2 seconds to exit the program mode, a “beep” sounds and the LED
will stop flashing and turn off.
5 .The Chime receiver is now programmed to sound your chosen tone when the TX is activated.
The Auto programming MODE will expire after 5 minutes (four “beeps” will indicate this).
Alternatively you can exit Auto Programming manually by pressing the the Program button for two
seconds, a “beep” sounds and the LED will stop flashing and turn OFF.
Changing the Alarm function at a later time.
1. press the Program button for 1 to 2 seconds. (1 “beeps will sound and the LED will flash
indicating it is in PROGRAM MODE).
Note:- Pressing the PROGRAM button for more than 5 seconds will erase all the
pragrammed codes.
2. Activate the Transmitter. Press the Tone/Volume button to select the preferred chime sound.
3. Exit the Program Mode by pressing the PROGRAM button for 1 to 2 seconds. (1 beep will
sound and the LED will stop flashing and remain ON, indicating the receiver is in AUTO MODE).
Alternatively the Auto programming MODE will expire after 5 minutes (four “beeps” will indicate
this).
VOLUME:
To set the volume for the chime tone, activate the Tx and the Rx will play the tone you have
chosen. Press VOLUME button. There are three settings. High, Low and “beep”. Scroll to the
volume you require.
You cannot change the volume whilst the Chime Rx is in PROGRAM MODE
ADDING ADDITIONAL TRANSMITTERS
The Chime Rx can be programmed to operate with up to 16 additional Transmitters. These
products are easily added to expand your system.
To add additional Tx`s, press the Rx PROGRAM button for 1 second while the Rx is powered.
DO NOT PRESS FOR LONGER THAN 2 SECONDS AS YOU MAY ERASE ALL EXISTING
CODES.
The Rx will "beep" and the LED will blink slowly for up to 5 minutes indicating it is in PROGRAM
MODE.
During this time simply activate the add on Tx by walking in its detection zone. The Rx
acknowledges the signal with a default tone (and the lamp turns ON if so programmed). This code
is stored in the Chime Rx along with the existing codes.
As previously, to Program the Rx audible signal triggered by the added TX, press the Tone/Volume
button and scroll through the options, then make a selection.
Change the volume with the TONE/VOLUME button after approximately 5 minutes when the
Chime Rx will have automatically exited PROGRAM Mode.
You cannot change the volume whilst the Chime Rx is in PROGRAM MODE.
SF-DCC-RX.qxd 13/04/2005 13:30 Page 5
