3
Installation
1.
Select a suitable position on the wall or ceiling to install
the camera. Take the mounting bracket off the dome
camera by unscrewing the fixing screw using the Allen key
supplied.
2.
Rotate the upper ring of the camera, it will unscrew from
the dome base. Be careful when handling the camera as
the parts are not fixed to the upper ring or the camera
‘ball’.
3.
Using the Dome base as a guide, drill a hole in the middle
of the base circle on the wall or ceiling where the camera
is to be mounted, to allow the power and video cable to
be fed through.
4.
Screw the Dome base to the wall or ceiling using the Wall
Plugs and screws supplied.
5.
Feed the Camera’s cable through the hole and adjust the
Camera ‘ball’ so the camera is positioned in the correct
direction and at the correct angle.
6.
When the camera is in the correct position, put the upper
and lower ring of the camera back into position. Secure
the upper ring back onto the base to secure the camera in
place.
7.
Connect the power terminal of the camera to a 12V DC
regulated power supply. Connect the camera video output
and the video input on the control or viewing equipment
with RG59 (BNC) video signal cable.
8.
Once installed the camera’s Zoom & Focus can be altered
by adjusting corresponding screws either side of the lens,
using the screwdriver provided.
1
2
12v DC Input
Power Cable
BNC
Video Cable
7