
Product Description of BRT-410
Page 4 of 5
Shenzhen Asia Bright Industry co., Ltd., Building 10, Asia Industrial Park, Gangtou, Bantian, Shenzhen, China.
© 2015 All rights reserved. Subject to change without notices.
There are three easy steps:
Step one:
Use a screwdriver to pry off the front plate in position A;
Step two:
Wiring according to the diagram and the labelled ports of the switch; and
Step three: Install screws and front plate.
BRT-410 Timer Switch Setup:
1.
Power the switch with 220 voltages: following the wiring diagram and Installation Guide.
2.
Set up Clock Time:
Press and hold the
SET
button until the displayed hours flash. Press –
or
+
to adjust the hours. Press the
SET
button again, the displayed minutes will flash, and
then press – or
+
to adjust the minutes. Press the
SET
button again, the displayed day of the
week will flash, and then press – or + to adjust the day. Finally, press and hold the SET button
to save the settings.
3.
Set up Timing Period for the First Load:
3-1. Set up the “On” time:
Press and hold the
I
button until the display shows “ON” and
“01” and the displayed hours flash. Press – or + to adjust the required “on” hours. Press
SET
button, the displayed minutes flash, and use – or + to adjust the required “on” minutes; and
3-2. Set up the “Off” time:
Right after setting up the “on” time, press
SET
button again,
and the display shows “OFF” and “01” and the displayed hours flash. Press – or + to adjust
the required “off” hours. Press
SET
button again, the displayed minutes flash, and use – or +
to adjust the required “off” minutes.
(During setup step 3-1 and 3-2, hold the – or + will adjust the digits quickly.)
At this point, both the “on” time and the “off” time have been set up for timing period #1.
3-3. Set up more timing periods: Right after setting up the first timing period, pressing "
◁
"
or "
▷
" will enter setting up other timing periods. Follow the procedures above to set up the
timing periods accordingly. Up to 16 timing periods can be set up.
Finally, press and hold the
SET
button to save the settings or the settings will be saved
automatically if there is no keypad operation for 15 seconds.
4.
Set up Timing Period for the Second Load:
Pressing and holding the
II
button will start setup for the second load. Follow step 3-1
through 3-3 to set up its timing periods accordingly.