IPU Spring Starter, Operator'S Manual

Page: 18 / 24

P a g e | 18
Position Code Table
Code Angle '+' Code Angle '-'
1A 0 1A 0
2B 8.6 6G 8.6
3C 17.1 5F 17.1
4D 25.7 4E 25.7
5E 34.2 3D 34.2
6F 42.9 2C 42.9
1G 51.4 1B 51.4
2A 60 6A 60
3B 68.6 5G 68.6
4C 77.1 4F 77.1
5D 85.7 3E 85.7
6E 94.2 2D 94.2
1F 102.9 1C 102.9
2G 111.6 6B 111.6
3A 120 5A 120
4B 128.6 4G 128.6
5C 137.1 3F 137.1
6D 145.7 2E 145.7
1E 154.2 1D 154.2
2F 162.9 6C 162.9
3G 171.4 5B 171.4
4A 180 4A 180
Fig 4 Fig 5 Fig 6
Note: The six through holes on the front housing are designated by numbers 1 to 6 clockwise,
looking from the rear of the housing (Fig 6).
The seven radial tapped holes on the rear housing are designated by letters A to G clockwise,
looking from the rear of the housing (Fig 4).
On the starter body, only two of the holes at either end are in line. These are marked with ‘O’ next
to each hole (Fig 5).