IPS HHP6-IPS, Manual, Page: 2 / 2

Innovative Parts and Solutions Ltd. : 20125 Stewart Crescent, Maple Ridge, BC, Canada V2X 0T6
Phone: 604-465-8994 FAX: 604-465-4397 E-mail: Info@railwayparts.com www.railwayparts.com
Hammer Handle Press
Part: HHP6-IPS
USAGE INSTRUCTIONS:
1.
To remove a broken handle on a tool,
first insert the new handle through the
hollow steel section so that the tool end
of the handle is up and the bottom end
of the handle is positioned in the round
jack adaptor on top of the jack.
2.
Insert the jack handle provided and
ensure the valve handle is set to allow
the jack to extend. jack adaptor on top
of the jack.
3.
Take the damaged tool, center the head
on top of the new handle and then
rotate the hammer head locator
assembly as shown below. Pump the jack
until there is contact between the top of
the new handle and the handle in the
head of the old handle. Continue to
pump the jack so that the new handle
forces the old handle out of the tool
head.
4.
Once the old handle has been removed
and the new handle is fully inserted, use
a hammer to drive a small steel wedge
into the end of the new handle to fully
secure the tool head to the new handle.
Replacement Wedges -
2310102A-01, -02, -03, -04