,3
3(
&
1
Pexatherm LCD Programmable Thermostat
1. INTRODUCTION
The Pexatherm LCD thermostat can replace most common indoor residential thermostat and is designed to
be used with electric, gas or oil heating system.
1.1 Features
Several useful functions and operating modes have been incorporated to adapt to a variety of customer
needs.
•
LCD shows the “NEED TO KNOW” Information only, which is more easy
to understand
•
8 programs for weekdays, Saturday and Sunday.
•
Real Time Clock with Day Display
•
Room Temperature Display
•
Simple Temperature Adjustment
•
Simple Programming Procedure
•
Manual Set-Temperature Override
•
2 x AAA Size Alkaline Batteries (Not Included)
•
Low Battery Indication
•
Heater Operation Mode
•
Compact Design
2. INSTALLATION
The Pexatherm thermostat has been designed for simple and quick installation requiring only a few tools
Caution:
1.
The appliance can only be mounted on dry indoor places.
2.
A suitable fuse with 5A rating should be in the power line.
3.
Observe the national regulation for the winter.
4.
Qualified electrician is recommended for installation and servicing.
2.1 Required material:
Hammer, Masking tape, Drill and 3/16” drill bit, Screwdriver
2.2 Removing your old thermostat
Caution:
1.
To avoid electric shock, turn off the power of heating system at the main power box in your home.
Read the following instructions carefully before disconnecting the wires.
2.
Remove the cover from the old thermostat.
3.
Unscrew the old thermostat from the wall plate.
4.
Unscrews the wall plate and pull a small distance from the wall. Do not disconnect any wire yet.
Warning:
High voltage is dangerous. Please consult a qualified electrician if in any doubt.
2.3 Choosing a Location
For a new installation, choose a mounting location:
1.
About 5 feet (1.5 meter) above the floor in an area with good air circulation.
2.
Away from: Draughts, air ducts, radiant heat from the sun or appliances, concealed pipes and
chimneys
3.
The best viewing angle is 12 o`clock direction.
2.4 Wall Mounting
1.
Remove the front housing of the thermostat by using a screwdriver.
2.
Mark the holes` position and align the wire coming from the wall in the hole beside the connectors.
3.
Drill two holes and insert the plastic plugs carefully into the holes until they are flush with the wall.
4.
Fasten securely the thermostat to the wall with the screws.
Display
