It is gigabit Ethernet fiber optic transmission equipment which can converter between two different network
cables and optical fiber transmission medium. Supporting 10/100/1000 Mbps network bandwidth, this
product can be used in pairs and also can be used with other equipments. It is widely used in surveillance,
home network fiber, etc.
Feature
Provide 1000Mbps 1 fiber optic port and 1 Ethernet port which can converter between
10 /100 /1000BASE-TX and 1000BASE-FX;
Use SFP optical module, support hot plug and SFP optical module with different performances ;
Compatibility with IEEE 802.3, IEEE 802.3u, IEEE802.3ab/z, and Ethernet standard of
10/100/1000BASE-TX and 1000BASE-FX;
Support 10/100/1000Mbps full/half duplex automatic adaptation and automatic MDI/MDIX.
Gigabit Ethernet Converter
1
2
Gigabit Ethernet Converter
Caution
1
)
Please
attention
that
2
optical
fibers
need
to
be
across
connected with
Fiber Port
of
two
Gigabit
Ethernet
Converters;
2
)
SFP module need to purchase additionally.
3
)
The equipment requires lightening protection, otherwise its protection level will be greatly reduced.
please use 20th or over wire to connect ground port to the ground ,
Application
Eth
ern
et S
witc
h
Giga
bit E
thern
et
Con
verte
r
Eth
ern
et S
witc
h
Giga
bit E
thern
et
Con
verte
r
O
ptic
al F
ibe
r
O
ptic
al F
ibe
r
Power
Input
Grounding
Terminal
Power
SD
FED
Link
SD
FED
Link
Fiber
Ethernet
Port
Power
&
Fiber
LED
Indicator
Fiber
Port
Board
Diagram
Rightside
Leftside
LED
Function
Status
Instruction
Power
Power
LED Indicator
On
Power
On
Off
Power
Off
FED
SFP
Detection Indicator
On
SFP
Insert
Off
Without
SFP Insert
SD
Remote
Device Failure
Detection
Indicator
On
Remote
Device Failed
Off
Remote
Device Communication Normal
Link
Optical
Fiber
port
Connection
Status
On
Connection
Normal
Flicker
Connection
Normal And With Data Switch
Off
Connection
Falied
RJ 45
Indicator
（
Link
/
Act
）
Ethernet
Port
Connection
On
Ethernet
Port
Connection
Normal
Flicker
Connection
Normal and With
Data
Switch
Off
No Connection
LED Indicator
Instruction
：
Please check the following items before installation. If any missing, please contact the dealer.
Power Adapter
Gigabit Ethernet Converter
1pc
1pc
Hanger
2 pcs
1pc
User
Manual
Installation
Installation
Steps
1) Please turn off the signal source and device power before installation; Installation with power on may
damage the device;
2) Please check if the network cables being taken up by other devices;
3) Use network cable to connect RJ45 Port of the Converter with NVR or network devices like
computer;
4) Use two single mode optical fibers tor connect two fiber ports of two Fast Ethernet
Converters. Pay attention to that the optical fibers connecting RX and TX line should be CROSS
connected. That is: if one end of optical fiber line connected to the module TX interface, the other end
should be connected to the RX interface;
5) Please check if the installation is correct and power the system;
6) Please check if the network is working.
