DESIGNED
AND MADE
IN THE USA
SA-DPN-1S-P
DP IN
AUDIO OUT
DP OUT
USB IN
USB OUT
CAC IN
CAC OUT
AUDIO IN
SA-DPN-1S-P
CONSOLE
AUDIO
K/M
CAC
DP OUT
EDID LEARN
HARDWARE INSTALLATION
A full Manual can be downloaded from
www.ipgard.com/documentation/
The KVM is designed to learn a connected
monitor’s EDID upon power up. In the event
of connecting a new monitor to the KVM, a
power recycle is required.
The KVM will indicate the unit’s EDID learn
process is active by flashing the front
panel’s LED. The LED will flash green for
approximately 10 seconds upon beginning
the EDID learn. Once the LED stop flashing,
the power will cycle and the EDID learn will
be complete.
A monitor must be connected to the video
output port located in the console space at
the back of the KVM during the EDID learn
process.
If the read EDID from the connected monitor
is identical to the current stored EDID in the
KVM then the EDID learn function will be
skipped.
1. Ensure that power is turned off or disconnected from the unit and the computer.
2. Use a DisplayPort cable to connect the DisplayPort output port from the computer to the
corresponding DP IN port of the unit.
3. Use a USB cable (Type-A to Type-B) to connect a USB port on the computer to the respective
USB ports of the unit.
4. Optionally, for CAC models, connect a CAC (Common Access Card, Smart Card Reader) to the
CAC port in the user console interface.
5. Optionally, connect a stereo audio cable (3.5 mm to 3.5 mm) to connect the audio output of
the computer(s) to the audio in ports of the unit.
6. Connect a monitor to the DP OUT console port of the unit using a DisplayPort cable.
7. Connect a USB keyboard and mouse in the two USB console ports.
8. Optionally, connect stereo speakers to the audio out port of the unit
9. Finally, power on the KVM by connecting a 12VDC power supply to the power connector, and
then turn on the computer.
Note:
You can connect 1 computer to the 1 port KVM.
A full Manual can be downloaded from
www.ipgard.com/documentation/
