Safety instructions
-
Read the instruction manual carefully before operating!
-
Mounting, installation and setting may only be carried out by qualified personnel!
-
Never use these products in applications where the safety of a person depends on their functionality!
Notes
-
Insert only anti-twist pistons on the cylinder!
-
Use exclusively the enclosed hexagon socket key or a plastic pen!
-
Check periodically the fittings and plug-in connections!
Start up
1.
2.
1. Insert the sensor from above at centre into the C-
groove and fix it with the enclosed hexagon socket key.
Pay attention on the centre of the sensor . The maximum
tightening torque is 0,1Nm.
Then connect the operating voltage (please note the
technical data and the connection diagram).
2. Teach-in of the switching points
-
Determine the piston position for switching point 1.
-
Press the teach-button for 3 seconds, LED 1 flashes.
-
Release the teach-button, switching point 1 is
stored.
-
LED 2 flashes.
-
Determine the piston position for switching point 2 .
-
Press briefly the teach-button, switching point 2 is
stored.
3. Control of the switching points
Move the piston into the position for switching point 1.
LED 1 has to light up. If it doesn’t light up, check the
operating conditions and teach the switching point
again.
Move the piston into the position for switching point 2.
LED 1 has to switch off and LED 2 has to light up.
If LED 1 doesn’t switch off or LED 2 dosn’t light up,
check the operating conditions and teach the device
again.
MANUAL
• Subject to alteration! Version: July 2015
ipf electronic gmbh
• Rosmarter Allee 14 • 58762 Altena
│
Tel +49 2351 9365-0 • Fax +49 2351 9365-19
www.ipf-electronic.com
2