ipf electronic PY740025, Manual

Page: 26 / 67

MANUAL [ PY740025/26 ]
•
Subject to alteration! Version: 22.10.2018
ipf electronic gmbh • Kalver Straße 25 - 27 • 58515 Lüdenscheid │ Tel +49 2351 9365-0 • Fax +49 2351 9365-19 │ info@ipf.de •
www.ipf.de
26
5.5.1 No
The FLEX MOUNT function is switched off by "No", the sensor can be mounted again at a right angle.
If FLEX MOUNT is not activated, a 0° angle and "distance" = end of measuring range Sde
1
are set.
The angle symbol disappears from the display.
5.5.2 Yes
FLEX MOUNT is activated in this menu.
Next, "Place the reference (REF)" is output by the sensor and then the sensor must be aligned to the
reference surface (or the auxiliary plate if there is no reference surface). The reference surface must be within
the sensor's measuring field (distance from sensor to reference surface less than distance from sensor to end
of measuring range Sde). The reference surface must fulfill the requirements.
Auxiliary plate
To compensate for unevenness, a flat temporary auxiliary plate can be used for this process. It is placed on
the reference surface during teaching-in and removed after the process.
This plate should be as flat as possible and must conform to the "minimum length of reference surface"
1
. The
plate must be positioned parallel to the reference surface below it. The thickness of this plate is not important
as long as it is within the measuring field of the sensor. The thickness of the auxiliary plate can be removed at
the end of the process by using “CORRECTION”.
1
According to data sheet chapter 6.1
NOTE
As soon as FLEX MOUNT is activated, SCALE OUT,
FIELD OF VIEW
and DIGITAL OUT are
reset to the standard settings (SCALE OUT and
FIELD OF VIEW
= maximum measuring field,
DIGITAL OUT = End of measuring range Sde
1
).
Auxiliary plate during the
teach-in process
Reference surface
uneven
M
K
Left Right
Minimum length of reference
surface or auxiliary plate
Distance between
sensor and reference
surface
CORRECTION (in mm)
NOTE
The following menu items TEACH REF and CORRECTION must be completed so
that FLEX MOUNT can be activated.