8.2.
Digital trigger mode
Digital trigger mode uses the digital input of the camera in order to start or stop recording (depending on the settings
for <Ring buffer stop mode>).
Connection plan for digital trigger mode
The camera trigger must be connected by technical personnel!
Use the genuine manufacturer cable!
8.3.
Use of interface protocols
General notes on protocol usage: Move the mouse over the text field, then examples for protocol entries are shown!
Ensure that network connections are not blocked and that devices to be connected are in the same address range!
1. Select an already stored configuration or create a new configuration by renaming. Saved/deleted by clicking
on (6).
2. Basic data for the connection - each protocol has its own standards.
3. Entry of the basic communication signals - Entry dependent on "Stop ring buffer mode" option“
„Ready“ makes operating visualisation for the PLC possible - this variable does not always need to be used!
4. Up to 3 signal variables can be specified
The types of variables are assigned in the secondary selection (the information is not mandatory – notes in
the help text)
5. Adjusting the delay after detection of the trigger signal
6. If a saved configuration is selected, it can be deleted by clicking on <Delete>.
If a new configuration is created, the text changes to „Save“ and the newly created configuration can be
saved.
1
2
5
6
4
3
MANUAL • Subject to alteration! Version:
September 2019
ipf electronic gmbh • Rosmarter Allee 14 • 58762 Altena
│
Tel +49 2351 9365-0 • Fax +49 2351 9365-19
│
[email protected] • www.ipf-electronic.com
12
