iPECS iPECS-LIK, Feature Description & Operation

Page: 84 / 447

iPECS-LIK
Feature Description & Operation Manual
Issue 6.0d1
71
2.23.3 Unsupervised Conference
Description
An iPECS phone user may establish a conference with external parties and exit the conference
while allowing the external parties to converse privately without supervision from the user.
The system will disconnect the Unsupervised conference if disconnect is detected with only two
parties connected or at expiration of the Unsupervised Conference timer. Fifteen seconds prior
to expiration of the timer, a Disconnect Warning Tone is provided.
If enabled, either party in an Unsupervised Conference can request the Unsupervised
Conference timer be extended. The party enters the Timer Extension feature code and a digit 1
to 9 indicating the Timer extension multiplier. The system will then extend the timer based on
the dialed digit multiple of the Timer. For example, if the Unsupervised Conference timer is 5
minutes and the user dials the digit 4, the timer will extend to 20 minutes (4 multiplied by 5
minutes).
Operation
iPECS Phone
To set up an Unsupervised conference
1. Establish normal conference.
2. Press the [CONF] button. The [CONF] button LED flashes to indicate the
Unsupervised Conference state.
To reenter the Unsupervised conference
1. Press the flashing [CONF] button.
Conf Party
To extend the Unsupervised Conference from a connected party
1.
Dial “# #”.
2. Dial the Timer extension multiplier (1~9).
Conditions
1. The Unsupervised Conference Timer also applies to an external call placed by a
DISA user.
2. An Unsupervised conference will be terminated if the system receives a disconnect
signal or the Unsupervised Conference Timer expires.
3. An Unsupervised Conference will not recall the user.
Programming
NUMBERING 1 Unsupervised Conference Timer Extension Code
(PGM 109-Btn 3)
STATION 1 Off Net Forward (PGM 111-Btn 14)
SYSTEM 1 CO to CO UC Time Extension (PGM 160-Btn 12)
1 Unsupervised Conference Timer (PGM 182-Btn 5)