Indicator description:
Indicator
Status
Description
OFF
Power Indicator: PWR
Green LED ON
Power ON, Normal Power Supply
Power OFF or Power failure
1000M
SPD
indicator
Green LED ON
Working condition 1000M
Green LED
OFF
Working condition 10/100M
PoE indicator:
POE
Green LED ON
Connected standard PD, Normal Power Supply
Green LED Blink
Short Circuit or Over Load
OFF
No Connection or Connected PD is Non-Standard PD
Connection Diagram
Installation guide
Connect to RJ45 port
1.Connect one end of RJ45 wire to switch, the other end to other equipment, as
shown as the figure on the right;
2.After power on, please check the LED indictor status. If it is on, it shows the
link is OK, otherwise, the link is down. Then please check the link and make
sure the other equipment is turned on, refer to the instruction on above page
for details.
Connect to power
PoE switch adopts AC 100-240V, 50/60Hz.
1.Please check the power supply specification matches with the required;
2.Connect switch power wire to AC power socket, shown as in the following figure.
Power Supply Connection Figure
Mounting Kits Installation Figure
Rack Installation Figure
L Angle Iron
Screw
After installation, please check:
If there is enough space for heat sink; if the power socket is suitable for switch specification; if the power, switch and rack are
properly grounded and if the connection between switch and other network equipments are normal.
Detailed descriptions for the product model numbers
IPCP-24P2G-AF2
24-port 10/12-port 10/100/1000Mbps up-link Ethernet port switch , No. 1-24 ports
support POE , IEEE802.3af/at, POE port output :
30
watts , total power : 250watts
PoE S
witc
h
Pow
er
Mo
nito
r
NV
R
Cat
.5
Vid
eo l
ine
PoE
Cam
era
IP
IP
Cam
era
PoE S
plit
ter
DC
OU
T
Cat
.5
PD-Powered Device
Power over Ethernet Splitter
OFF:12V
ON:5V
PoE RUN
PoE IN
DC
OUT
DC
RUN
Ethernet out
IN
OUT
Cat
.5
PoE I
P
Cam
era
PoE I
P
Cam
era
Rj45 port
Plug
Link/ACT indicator
Yellow LED ON
Co
nected port correctly
Yellow LED Blink
Receiving or Sending data
OFF
Connection failed or Abnormal Link
PoE Indicators:
The front panel has light indicators showing the status of PoE activity.
Network Traffic Indicators:
The front panel has light indicators showing status of network activity.
SFP Gigabit fiber port:
Two combo fiber port
s
, all port
s
support wire-speed forwarding, Rich port configuration.