REPLACING THE SQUEEGEE BLADES
ATTACHING/REMOVING THE BRUSHES
Open the clip (Ref. 1).
Remove the two blade retainers (Ref. 2) by pushing them outwards then extracting them.
Remove the blade.
Reuse the same blade by reversing the edge in contact with the floor until all four edges are worn out, or replace with a new blade, fitting it onto the
screws on the body of the squeegee.
Reposition the two blade pressing devices by centering the wider part of the slots on the squeegee body fastening pins, then push the blade pressing
devices inwards.
Close the hook again.
Replace the squeegee on its support, following the instructions described previously.
Brush attachment, fit the rollers in their housing by first inserting them on the drive pulley, then pushing them upwards until they click into place.
Brush removal, release the brushes by pulling them downwards from the side opposite the drive pulley, then extracting them from their housing.
DAILY MAINTENANCE
Clean the dirty
water tank.
Check that the suction filter
and dirt filter are clean.
Check that the
detergent outlet filter
is clean.
Check that the
squeegee is clean
and the blades are not
worn.
Check that the brushes are
clean. Replace if necessary.
PLDC04369
1
2
FILTER
BATTERY CHARGER ON BOARD
BATTERY CHARGER STAND ALONE
24V