REPLACING THE SQUEEGEE BLADES
ATTACHING/REMOVING THE BRUSH
•
unscrew the nuts fixing the blade retainers;
•
remove the two blade retainers;
•
remove the blade;
•
put the same blade back, reversing the edge in contact with the floor until all four edges are worn, or replace with a new one;
•
put the two blade retainers back on the squeegee and screw up the nuts again;
Attaching the brush:
•
rest the brush on the floor in front of the machine. Raise the front of the machine by levering on the handle, then lower it onto the brush, centring it with the brush cover. Action the drive lever repeatedly until the brush
engages..
Removing the brush:
•
Raise the front of the machine by levering on the handle, then operate the brush lever repeatedly. After operating the lever a few times, the brush is released and falls to the ground.
DAILY MAINTENANCE
Clean the dirty
water tank.
Check the dirty water tank float
is undamaged and clean and
moves freely on the pin.
Check that the
detergent outlet filter
is clean.
Check that the brush is clean.
Replace if necessary.
Check that the
squeegee is clean
and the blades are not
worn.
PLDC01957
BATTERY
CHARGER ON
BOARD