ENGLISH
11
IMPORTANT
Mount the batteries on the machine using lifting means suitable for their weight.
The positive and negative poles have different diameters.
•
Referring to the wiring layout shown in the above diagram, connect the battery cable
and bridge terminals to the battery poles. Arrange the cables as shown in the
diagram, tighten the terminals on the poles and cover with Vaseline.
•
Lower the dirty water drum into the working position.
•
When using the machine, follow the instructions below.
5.4.3. Batteries: removal
!
DANGER
When removing the batteries, the operator must be equipped with suitable personal
protection devices (gloves, goggles, overalls, safety shoes, etc) to reduce the risk
of accidents. Make sure the switches on the control panel are in the "0" position
(off) and the machine is turned off. Keep away from naked flames, do not short
circuit the battery poles, do not cause sparks and do not smoke. Proceed as
follows:
•
disconnect the battery wiring and bridge terminals from the battery poles.
•
if necessary, remove the devices fixing the battery to the base of the machine.
•
Lift the batteries from the compartment using suitable lifting equipment.
5.5.
The battery charger
IMPORTANT
Never allow the batteries to become excessively flat as this could damage them
irreparably.
5.5.1. Choosing the battery charger
Make sure the battery charger is compatible with the batteries to be charged:
−
tubular lead batteries: you are recommended to use a 24V-20A automatic battery
charger. However, you should always consult the battery charger manufacturer and
manual to confirm the choice.
−
gel batteries: use a charger specific for this type of battery.
5.5.2. Preparing the battery charger
If you wish to use a battery charger not provided with the machine, you must fit it with the
connector supplied with the machine (see paragraph "Unpacking" of this manual).
To install the connector, proceed as follows:
•
remove about 13 mm of protective sheath from the red and black wires of the battery
charger;
•
insert the wires into the connector contacts and squeeze them forcefully with suitable
pliers;
•
respect the polarity (red wire + black wire –) when inserting the wires into the
connector.
5.6.
Lifting and transporting the machine
IMPORTANT
All phases must be performed in an adequately lit room and adopting the safety
measures most appropriate to the situation.
The operator must always use personal protection devices.
