3
3. Insert polar scope all the way into the scope housing, as shown in Figure 3. The polar scope
will be tight fitted into the scope house. Secure the scope by lightly tightening the set screw.
DO NOT over tighten the locking screw.
It may damage the polar scope body and lens.
Figure 3. Install polar scope
Install polar scope illumination LED
1. If there is a bar in the middle of the polar alignment opening as shown in the Figure 4, the
SmartEQ mount already has an illumination LED as part of the main control board.
If you can’t
see through the polar alignment opening, it is blocked by the DEC axle. Please turn the mount
on and use the UP or DOWN arrow key on the hand controller to rotate the DEC axle until you
can see through the opening.
Figure 4. SmartEQ
TM
with integrated polar scope illumination LED
Please go to the Operation part for polar alignment.
1
2
