IMPORTANT: Do not operate the unit without the filters and UV light
installed.
1. One HEPA filter, one activated carbon filter, ultraviolet light and two
photocatalyst filters are pre-installed. There is nothing further to install in
order to start using the unit.
2.
To use the built-in Aromatherapy function, press the cover in to release the
tray, then remove the plastic cover and add the essential oil of your choice
to the cotton pad. Replace the cover and tray into the unit. To remove or
replace the tray, simply push in.
3. Plug the adapter into the proper power source.
4. Press the POWER button to turn the unit ON. The LED on the left side will
glow Red.
Press the POWER button again to turn the unit OFF. The LED will turn OFF.
The ioniser and UV light will always be switched on when the power for the
unit is turned ON.
5. Press the SPEED button to adjust the airflow between HIGH (red indicator)
and LOW (green indicator).
Tips:
•
For quick air cleaning, set the speed control to HIGH. After about 30
minutes, set the speed control to LOW.
•
To maintain fresh air at all times, set the speed control to LOW. The unit
uses very little electricity.
•
For quiet use in the evening, set the speed to LOW.
OPERATING INSTRUCTIONS
POWER SPEED
4
