9
Linking Two Speakers
To wirelessly link two Total PA
TM
Spartan speakers:
1.
Power on both speakers using their
Power Switches
.
2.
With no Bluetooth connected, press the
Mode
button on one Total PA
TM
Spartan to select
Bluetooth as the audio source, which appears as "
bt
" in the display. This will be the "secondary"
speaker.
3.
Press the
Link
button on a second Total PA
TM
Spartan to enter Stereo Link Mode. This will be the
"primary" speaker.
4.
Wait up to 1 minute for the speakers to make the connection. Once the two speakers are linked,
press the
Mode button
on the "primary" speaker to select the desired audio source.
5.
To disconnect, double-press the
Link
button on the "primary" speaker.
To link two Total PA
TM
Spartan speakers using cables:
1.
With the
Power Switch
on each speaker turned to the off position, connect each speaker to a
power outlet.
2.
Plug an XLR cable into the
Mix Out
located on the rear panel of one Total PA
TM
Spartan speaker.
This speaker (the primary) is the one to which you will connect audio sources such as a Bluetooth
device, microphone, or USB flash drive.
3.
Plug the other end of the XLR cable into the
XLR Input
on the rear panel of your second Total
PA
TM
Spartan speaker. This second speaker will receive the audio from any devices connected to
the first speaker (the primary).
4.
Power on both speakers using their
Power Switches
.
5.
Connect your audio sources to the first speaker (the primary).
6.
Make sure that each speaker’s
Master Volume
control is set to the same position.
7.
With one of your audio sources playing, gradually turn up the
Aux Input Volume
on the second
Total PA
TM
Spartan speaker until the volume of this speaker matches the volume of the first
speaker (the primary).
