6
Pairing a Bluetooth Device Using NFC
NFC (near-field communication) allows data exchange from devices, such as pairing, by gently
bumping them together. Check in your device’s manual to see if this feature is supported.
To use NFC to pair with Solar Rocker:
1.
In order to use NFC, your device must be turned on and unlocked.
2.
Enter your device’s
Settings
menu and check that
NFC
is turned
On
(one-time step).
3.
Power on Solar Rocker.
4.
Touch and briefly hold your device to the NFC logo located on Solar Rocker’s top panel.
5.
Follow the pairing instructions that appear on your phone. If a passcode is required, enter
“
0000
”.
6.
To unpair, gently bump your device against the NFC logo.
Troubleshooting
If the sound is distorted:
Try lowering the volume control of your sound source, musical
instrument, or microphone. Also, try to reduce the overall volume of Solar Rocker using the
Master Volume knob.
If there is too much bass:
Try adjusting the tone or EQ control on your sound source to lower
the bass level. This will allow you to play the music louder before clipping (distortion) occurs.
If there is a high-pitched whistling noise when using microphones:
This is probably
feedback. Point the microphone away from the speaker.
If there is poor AM reception:
To adjust AM reception, move entire unit.
If you can’t hear the microphone over the music volume:
Turn down the music volume
from your source.
If you can’t play music from a flash drive:
The USB port is only for charging USB devices.
If the unit is not charging:
Make sure the power cable is properly connected to the power
input and the power outlet. If you are using the solar panel for charging, make sure the unit is
receiving direct sunlight.
